Eternal Inverter 
12V/24V/36V/48V Auto 100A MPPT Solar Charge Controller
L-100 Series is a MPPT Solar Charge Controller designed for residential use.Maximum charging current 100A. It could maximizes energy extraction from the solar panel and more accurately tracks the maximum power point of the solar panel, thus significantly improving charging efficiency.Lightweight design, easy installation, low noise and friendly environment.
E-hybrid Power
When there is sunlight, the solar energy directly drives the use of household loads, and the excess electricity is stored in the battery to face emergencies; When the weather is cloudy or rainy, which leads to insufficient sunlight, part of the solar energy is complementary to the battery, which will not break the solar energy and simply use the battery to supply power
Multipurpose load port
Compared to the traditional MPPT solar charge controller, the E-Hybrid solar charge controller is equipped with a multi-function load port, which is normally open mode, light mode and residual electricity mode. Normally open mode refers to the normal output 24V load, can be open for a long time; Light control mode refers to the situation that lighting is turned on when there is no light, or it is hoped that the load will run when there is no light. Residual electricity mode means that when one of the conditions that the photovoltaic input is greater than the inverter load or the battery energy storage is more than 80% occurs simultaneously or only, residual electricity can be used to make water by air, pump water by residual electricity and make heat by residual electricity.
Change wiring mode
As can be seen from the figure, the wiring of the traditional MPPT solar charge controller is very complicated, and it needs to connect the battery and then supply power to the loads through the inverter, which will lead to the consequences of charging and discharging at the same time, which will not only affect the battery life, but also fail to use 100% electricity; The E-Hybrid solar charge controller is connected to the battery for storage alone, and the load runs through the inverter alone, which protects the battery life and outputs electricity with maximum efficiency at the same time
Leading feature
1.E-Hybrid Tech, Complementary of PV & Battery
2.Three-stage charging optimizes battery performance
3.Compatible for PV systems in 12V , 24V , 36V or 48V
4.Maximum charging current up to 100A
5.Automatic battery voltage detection
6.Supports lithium battery and various lead-acid batteries, AGM and gel battery
Specifications
| Model | L-100 |
| DC output | |
| Max Charging Current | 100A |
| System Voltage | 12/24/36/48V (Automatic recognition) |
| DC Max. Output Power (Automatic recognition of battery voltage) | 12V: 1200W |
| 24V: 2400W | |
| 36V: 3600W | |
| 48V: 4800W | |
| Battery Type | Gel / AGM / Liquid / LiFePO4 / Li-NMC |
| PV input | |
| Max. PV input power | 12V: 1333W |
| 24V: 2666W | |
| 36V: 4000W | |
| 48V: 5333W | |
| Max. open circuit PV Voltage | 195V |
| MPPT Voltage Range | 15~170VDC |
| General spec. | |
| Multifunctional DC output mode | Normal power on mode / Excess power output mode / Light control mode |
| Max tracking efficiency | >99.9% |
| Max charge conversion efficiency | 0.98 |
| Ingress Protection | IP30 (indoor & ventilate) |
| Operating Temperature Range | -10~55℃ |
| Operating moisture range | 5% to 95% |
| Max Operating Altitude | 2000m |
| Communication | RS485/wifi |
| Display | LED |
| Dimensions (mm) | 295×200×85 |
| Weight (Kg) | 6.5 |
| Protection | Over current / over voltage / undervoltage / high temperature |
